 |
 |
 |
|
|
|
[Sponsors] | ||||
Proam creates negative extrusion cells if away from origin |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 18, 2011, 17:18
|
Proam creates negative extrusion cells if away from origin
|
#1 |
|
New Member
Stephen
Join Date: Mar 2010
Posts: 21
Rep Power: 16  |
Why does the mesh have to be near the origin to create the extrusion layer? I have done a few meshes where they are away from the origin and everytime a few cells in the extrusion layer will be negative. If I move the mesh near the origin (0,0,0), then my extrusion layer comes out great with no negative volumes.
|
|
|
|
|
|
January 27, 2011, 05:02
|
|
#2 |
|
Senior Member
Joern Beilke
Join Date: Mar 2009
Location: Dresden
Posts: 498
Rep Power: 20 |
Just scale you mesh from meter to mm (vset all $ vsca vset ,,, 1000 1000 1000).
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Netgen] Import netgen mesh to OpenFOAM | hsieh | OpenFOAM Meshing & Mesh Conversion | 32 | September 13, 2011 05:50 |
| [snappyHexMesh] snappyHexMesh aborting | Tobi | OpenFOAM Meshing & Mesh Conversion | 0 | November 10, 2010 03:23 |
| [blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
| physical boundary error!! | kris | Siemens | 2 | August 3, 2005 00:32 |
Linear Mode
