es-ice/Tutorial problem doubt

Phanipavan · June 29, 2011, 12:52

when i am doing tutorial problem for es-ice using trimming method the following error occurs before creating 2-D template:

Error: The cells between valve 1(22) and valve 2(18) must agree.

Before storing section 1 and section 2 in create Template panel.

Is this due to trimming splines? or adjusting right triangle for inlet valve(section1)?

chili023 · July 1, 2011, 05:27

when creating the 2d template the 2 sides of section 1 and 2 (first and second mathematical quadrant) have to have the same amount of cells. So increase the number of cells in section 2 by 6.

chili023 · July 1, 2011, 05:28

sorry 4 of course.
I though it said 24.

Phanipavan · July 1, 2011, 13:30

Thanks chili for your reply,
Yesterday i adjusted the cells for respective valve(section) so that match occurs properly.

But during trimming process,
following error found

Error:Failed to cut the template,
could not close the surface because the edge of valve face was not found.

I think the edges of valves at junction should align properly then only trimming will occur.

June 29, 2011, 12:52	es-ice/Tutorial problem doubt	#1
Phanipavan New Member Pavan Kumar Join Date: Jun 2011 Posts: 5 Rep Power: 14	when i am doing tutorial problem for es-ice using trimming method the following error occurs before creating 2-D template: Error: The cells between valve 1(22) and valve 2(18) must agree. Before storing section 1 and section 2 in create Template panel. Is this due to trimming splines? or adjusting right triangle for inlet valve(section1)?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
UDF compiling problem	Wouter	Fluent UDF and Scheme Programming	6	June 6, 2012 04:43
New Cutcells method Ansys 13 symmetry problem and doubt	William D Acosta	ANSYS	1	June 8, 2011 10:33
natural convection problem for a CHT problem	Se-Hee	CFX	2	June 10, 2007 06:29
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 19:13
convergence problem	Trushar	Phoenics	5	August 27, 2002 23:40

July 1, 2011, 05:27		#2
chili023 New Member AB Join Date: Jun 2010 Posts: 21 Rep Power: 15	when creating the 2d template the 2 sides of section 1 and 2 (first and second mathematical quadrant) have to have the same amount of cells. So increase the number of cells in section 2 by 6.

July 1, 2011, 05:28		#3
chili023 New Member AB Join Date: Jun 2010 Posts: 21 Rep Power: 15	sorry 4 of course. I though it said 24.

July 1, 2011, 13:30		#4
Phanipavan New Member Pavan Kumar Join Date: Jun 2011 Posts: 5 Rep Power: 14	Thanks chili for your reply, Yesterday i adjusted the cells for respective valve(section) so that match occurs properly. But during trimming process, following error found Error:Failed to cut the template, could not close the surface because the edge of valve face was not found. I think the edges of valves at junction should align properly then only trimming will occur.