|
[Sponsors] |
July 28, 2014, 12:20 |
beam188 DOF release
|
#1 |
New Member
Diogo Rebelo
Join Date: Jun 2014
Posts: 5
Rep Power: 11 |
Hello,
I am having problems to simulate a pot bearing on a bridges' column-Deck connection. I tried the ENDRELEASE command but I can't figure out how to apply this command. By following the path: Main Menu>Preprocessor>Loads>Load Step Opts>Other>End Releases>Beams>On Selected set We are supose to chose a node (or a set) to set free the DOF's. But this command creates new nodes and makes the strucutre to split on those nodes. And I can't understand this behavior. Can someone please help? Thanks in advance, Diogo |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Release of foam-extend-3.0 | hjasak | OpenFOAM Announcements from Other Sources | 2 | September 21, 2014 08:08 |
Openfoam Ubuntu 12.04 Unmet dependencies | slls33 | OpenFOAM Installation | 10 | April 9, 2013 05:16 |
Force can not converge | colopolo | CFX | 13 | October 4, 2011 23:03 |
Extend Project Release 1.6-ext | hjasak | OpenFOAM Announcements from Other Sources | 33 | July 14, 2011 19:54 |
Diesel combustion simulation ( Heat release rate) | venkatesh | Siemens | 2 | April 29, 2009 08:38 |