Harmonic Analysis woth Displacement Loads

giorgio.parise · February 24, 2015, 11:48

Hi everybody,

I am trying to use the superposition of the mode for accelerating the calculation time of an Harmonic Analysis with ANSYS Mechanical APDL.

I build up a simple case with a beam fixed at one end and a displacement load at the other one. I build a simple table for the variable displecement respect to the FREQ primary variable.

Then I solved the Harmonic Analysis using the "Mode Superpos'n" Solution Method. But from the "file.mcf" I saw that all the Modal Coordinates were null.

Does anybody know if is possible or not to obtaing solution using only displacement load and not the "Full" Solution Method?

Thanks everybody in advage

Have a nice work with ANSYS

Giorgio

siw · February 25, 2015, 08:09

The simplest way I conduct modal super-position harmonic response simulations with a displacement boundary condition in ANSYS Structural (i.e. in the Workbench environment) is with the Enforced Motion ACT Extension from the ANSYS Customer Portal. Where it is listed for version 15.0 but it also works for version 16.0.

This ACT also allows for acceleration to be a boundary condition at surfaces. Both of these are very useful for simulating sine sweeps on vibration shakers.

I don't know about doing this in the ANSYS APDL (aka ANSYS Classic) environment as I don't use that.

February 24, 2015, 11:48	Harmonic Analysis woth Displacement Loads	#1
giorgio.parise New Member Giorgio Join Date: Oct 2014 Posts: 3 Rep Power: 11	Hi everybody, I am trying to use the superposition of the mode for accelerating the calculation time of an Harmonic Analysis with ANSYS Mechanical APDL. I build up a simple case with a beam fixed at one end and a displacement load at the other one. I build a simple table for the variable displecement respect to the FREQ primary variable. Then I solved the Harmonic Analysis using the "Mode Superpos'n" Solution Method. But from the "file.mcf" I saw that all the Modal Coordinates were null. Does anybody know if is possible or not to obtaing solution using only displacement load and not the "Full" Solution Method? Thanks everybody in advage Have a nice work with ANSYS Giorgio

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
snappyhexmesh remove blockmesh geometry	philipp1	OpenFOAM Running, Solving & CFD	2	December 12, 2014 10:58
[snappyHexMesh] determining displacement for added points	CFDnewbie147	OpenFOAM Meshing & Mesh Conversion	1	October 22, 2013 09:53
Harmonic extension	lingdeer	Main CFD Forum	0	February 20, 2012 14:56
Expression with time function	kestasposkus	CFX	28	July 24, 2011 06:47
how to use Total Mesh Displacement for making a subject translating and rotating?	snailstb	CFX	3	September 16, 2009 04:06

February 25, 2015, 08:09		#2
siw Senior Member Stuart Join Date: Jul 2009 Location: Portsmouth, England Posts: 733 Rep Power: 25	The simplest way I conduct modal super-position harmonic response simulations with a displacement boundary condition in ANSYS Structural (i.e. in the Workbench environment) is with the Enforced Motion ACT Extension from the ANSYS Customer Portal. Where it is listed for version 15.0 but it also works for version 16.0. This ACT also allows for acceleration to be a boundary condition at surfaces. Both of these are very useful for simulating sine sweeps on vibration shakers. I don't know about doing this in the ANSYS APDL (aka ANSYS Classic) environment as I don't use that.