|
[Sponsors] |
Workbench Target-Contact in different versions |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Member
Si Cy
Join Date: Mar 2016
Posts: 31
Rep Power: 9 ![]() |
I ran an analysis in workbench 16 but for the same analysis, I had to flip the contact and targets in workbench 17. I was wondering if Ansys has changed its conventions? The help for both the 16 and 17 version looks the same. Also, I need some examples on how you decide a surface should be target or contact. I know there are some guidelines for that in the help but in some cases, they were contradictory especially for complicated problems.
Thank you |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
Onur Özcan
Join Date: Feb 2016
Location: Istanbul/Turkey
Posts: 461
Rep Power: 11 ![]() |
if you solve thermal-dependent problem,it is not important anymore
|
|
![]() |
![]() |
![]() |
Tags |
contact, target, version, workbench |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 13:21 |
[waves2Foam] Waves2Foam Related Topics | ngj | OpenFOAM Community Contributions | 660 | August 20, 2018 12:39 |
FLUENT installation on UBUNTU 12.04 (LTS) | teymourj | FLUENT | 2 | March 1, 2017 22:24 |
Ansys Workbench contact problem! | JoelHenrik | ANSYS | 1 | October 1, 2010 14:57 |
OpenFOAM14 for Mac OSX Darwin 104 | gschaider | OpenFOAM Installation | 118 | July 20, 2008 05:19 |