|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Oskar
Join Date: Mar 2017
Posts: 2
Rep Power: 0 ![]() |
I'm very new to ANSYS workbench.
I'm wondering which of all the analysis systems I should use for a fluid flowing through a pipe which induces fast temperature change. I also wonder about when you set the temperature change: Is it the geometry's temperature you set or is it the ambient temperature? Thanks in advance. |
|
![]() |
![]() |
![]() |
Tags |
change, mechanical, temperature, thermal, thermal analysis |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Workbench - which analysis system to use? | atyy | ANSYS | 1 | April 20, 2013 10:27 |
Eigenfrequencies static and modal analysis | Laura_mecheng | ANSYS | 1 | May 15, 2012 03:40 |
Need help with analysis of a small compressor/diffuser system | jkbg38 | FloEFD, FloWorks & FloTHERM | 3 | October 3, 2009 06:44 |
Need help on FSI analysis and Re-meshing Approach | khinthida2005 | CFX | 5 | September 4, 2009 07:56 |
Need ideas-fuel discharge system | Jan | FLUENT | 1 | October 10, 2006 23:05 |