Nozzle Calculation based on ASME Sec. VIII Div-2 Part 5 & validation with ANSYS

mehul020892 · March 12, 2020, 01:56

How to create nozzle model for FEA in ansys static structural ?
I also want to know about the how to apply symmetric conditions and boundary conditions for symmetric configuration.

karachun · March 12, 2020, 07:15

Your question is too common. I suppose that no one will write 100+ pages tutorial about nozzle CAD and mesh modeling. Try to search some basic tutorials on youtube or Ansys Student Community, there are lot of info. You can also check resources like GrabCAD.com and download similar models for acquaintance.
Set up symmetry BC is quite simple, here is short video.
https://www.youtube.com/watch?v=EzdDeDRLq8s

mehul020892 · March 20, 2020, 22:52

Quote:

Originally Posted by karachun

Your question is too common. I suppose that no one will write 100+ pages tutorial about nozzle CAD and mesh modeling. Try to search some basic tutorials on youtube or Ansys Student Community, there are lot of info. You can also check resources like GrabCAD.com and download similar models for acquaintance.
Set up symmetry BC is quite simple, here is short video.
https://www.youtube.com/watch?v=EzdDeDRLq8s

Thank you for your reply but actually i want to know about how to apply load symmetrical and also . Want to calculate load exerted by geometry not modeled.

karachun · March 21, 2020, 05:19

Sorry, I do not understand your question. Can you be more specific. Some additional pictures will be fine.

March 12, 2020, 01:56	Nozzle Calculation based on ASME Sec. VIII Div-2 Part 5 & validation with ANSYS	#1
mehul020892 New Member Mehul Parmar Join Date: Feb 2017 Location: India Posts: 15 Rep Power: 9	How to create nozzle model for FEA in ansys static structural ? I also want to know about the how to apply symmetric conditions and boundary conditions for symmetric configuration.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ansys SIG$ILL error	loth	ANSYS	3	December 24, 2015 05:31
Hardware-Configuration for Fluent HPC-Pack (8x)	JohHaas	Hardware	9	March 3, 2015 13:25
[snappyHexMesh] crash sHM	H25E	OpenFOAM Meshing & Mesh Conversion	11	November 10, 2014 11:27
CFX-Pre problem, pls help!!!	cth_yao	CFX	0	February 17, 2012 00:52
Warning 097-	AB	Siemens	6	November 15, 2004 04:41

March 12, 2020, 07:15		#2
karachun Senior Member Join Date: Nov 2015 Posts: 244 Rep Power: 11	Your question is too common. I suppose that no one will write 100+ pages tutorial about nozzle CAD and mesh modeling. Try to search some basic tutorials on youtube or Ansys Student Community, there are lot of info. You can also check resources like GrabCAD.com and download similar models for acquaintance. Set up symmetry BC is quite simple, here is short video. https://www.youtube.com/watch?v=EzdDeDRLq8s

March 21, 2020, 05:19		#4
karachun Senior Member Join Date: Nov 2015 Posts: 244 Rep Power: 11	Sorry, I do not understand your question. Can you be more specific. Some additional pictures will be fine.