Contact element type 0 error
1 Attachment(s)
Hi everybody,
I'm having trouble with structural mechanical solutions for my biomedical model. I need to decrease mesh size because at the previously tested one the solution does not converge. However, when I decrease it the analysis stops in the early phase outputting the following error: "Contact element type 0 used for general contact surface defined by section ID 0 is also associated with other pair based contact element. This pattern is not supported. Please verify the model." I already tried looking for it around but didn't find anything helpful. Here attached you will find the whole solver output. Hope somebody could help me, this is a pretty annoying trouble. :\ |
All times are GMT -4. The time now is 23:20. |