FEA Structutal Analysis of Bulkhead

raza44 · May 20, 2020, 18:23

Hi Friends,
I am working on structural analysis of bulkhead design, but getting failed in meshing phase due to the size(6m*8m) and complexity of the structure design. i am open to any sujjestion regarding any technique to get quad meshed element.I am familiar with ANSYS and ABBAQUS,
so if you have any sujjestion, you are more than welcome to throw at me.

karachun · May 26, 2020, 07:45

Question is too common. No one will write a manual special for you. The only advice I can give to you is: read meshing manuals and watch youtube tutorials.
If you wand some help you should attach some test geometry that represents your problem.

May 20, 2020, 18:23	FEA Structutal Analysis of Bulkhead	#1
raza44 New Member raza khan Join Date: May 2020 Posts: 1 Rep Power: 0	Hi Friends, I am working on structural analysis of bulkhead design, but getting failed in meshing phase due to the size(6m*8m) and complexity of the structure design. i am open to any sujjestion regarding any technique to get quad meshed element.I am familiar with ANSYS and ABBAQUS, so if you have any sujjestion, you are more than welcome to throw at me.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Urgent - Perform an DISCRETE adjoint analysis in parallel_computation	JPBLourenco	SU2	1	April 23, 2018 10:38
Explicit dynamics results for initial condition to another explicit dynamics analysis	KOI	Structural Mechanics	0	March 2, 2018 04:16
Flutter analysis of compressor blade	sridharabc228	CFX	1	April 13, 2017 19:10
ANSYS WORKBENCH Transfer result of one analysis to a new analysis as preload	ingjuanm90	ANSYS	0	July 26, 2016 14:04
should i use fea or cfd for thermal analysis?	mr. bill	FLUENT	7	March 3, 2016 14:31

May 26, 2020, 07:45		#2
karachun Senior Member Join Date: Nov 2015 Posts: 244 Rep Power: 11	Question is too common. No one will write a manual special for you. The only advice I can give to you is: read meshing manuals and watch youtube tutorials. If you wand some help you should attach some test geometry that represents your problem.