Problems when using su2 to solve quick start tutorial in parallel version

wruudf · March 5, 2015, 20:02

I just installed su2 successfully and was trying to run the quick start tutorial in both serial and MPI version.
The serial one is as good as the picture in the tutorial but the parallel one is like a mess.
Is there any solutions except reinstall it?

btracey · May 19, 2015, 16:25

Do you have any console output or output from installing in parallel? It could be a problem with your MPI installation, or it could be a problem with the .vtk file in parallel. Does the simulation converge?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Superlinear speedup in OpenFOAM 13	msrinath80	OpenFOAM Running, Solving & CFD	18	March 3, 2015 05:36
Error swithcing between single e parallel version of fluent	bishop_house	FLUENT	0	February 28, 2011 12:14
Saving .cas and .dat from parallel version	Pfalcon	ANSYS	1	August 15, 2009 08:18
CFX - Parallel Problems	CFX User	CFX	0	November 1, 2004 18:12
Problems in Parallel PHOENICS	Zeng	Phoenics	3	February 27, 2001 13:28

May 19, 2015, 16:25		#2
btracey New Member Brendan Tracey Join Date: Jun 2013 Posts: 18 Rep Power: 12	Do you have any console output or output from installing in parallel? It could be a problem with your MPI installation, or it could be a problem with the .vtk file in parallel. Does the simulation converge?