 |
 |
 |
|
|
|
[Sponsors] | ||||
March 18, 2015, 10:24
|
Binary Tecplot support on Linux ?
|
#1 |
|
New Member
dcha
Join Date: Mar 2015
Posts: 1
Rep Power: 0  |
I tried to install SU2 (last version) on a Linux computer (OpenSuse 12.3) with support of binary Tecplot format and mpi
I used the following command: ./configure --enable-mpi --enable-tecio -prefix /shared/su2 mpi is correctly supported, but Tecio not  MPI support: yes Metis support: yes Parmetis support: yes TecIO support: no Thank you in advance for any idea to solve this problem ! |
|
|
|
|
|
May 12, 2015, 16:54
|
|
#2 |
|
Super Moderator
Thomas D. Economon
Join Date: Jan 2013
Location: Stanford, CA
Posts: 271
Rep Power: 14 |
Hi,
Were there any clues in your ./configure output that is printed to the console (at the beginning)? Sometimes, configure has trouble finding some of the required headers before the build begins that are related to X11. Can you please check that this header information is found? Hope this helps, Tom |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Resolved] GPU on Fluent | Daveo643 | FLUENT | 4 | March 7, 2018 08:02 |
| Error in solution using "Grid Interface" | agustinvo | FLUENT | 4 | January 20, 2015 12:03 |
| I created a tecplot binary file... | Lupocci | Tecplot | 6 | June 27, 2012 19:56 |
| How to write Tecplot binary file(.plt) in CFD code on Linux 64 platform? | markailee | Tecplot | 5 | December 16, 2010 07:03 |
| Error to re-open fluent case file | J.Gimbun | FLUENT | 0 | April 27, 2006 08:42 |
Linear Mode
