CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   SU2 Installation (https://www.cfd-online.com/Forums/su2-installation/)
-   -   Su2_ad (https://www.cfd-online.com/Forums/su2-installation/219067-su2_ad.html)

darshangowda046 July 14, 2019 07:09

Su2_ad
 
i am trying to install su2_AD but i am getting following error when i run this code
export CXXFLAGS="-O3 -Wall" && ./preconfigure.py --enable-autodiff --enable-mpi --prefix=/home/darshan/Downloads/SU2_V5



error msg says-


Checking the status of submodules
================================================== ===================

git command failed (either git is not installed or this is not a git repository).

Using fall-back method to initialize submodule CoDiPack

Initializing CoDiPack 'bd4a639c2fe625a80946c8365bd2976a2868cf46'
================================================== ===================
Downloading module from https://github.com/scicompkl/CoDiPack
Extracting archive ...
Creating identifier ...

git command failed (either git is not installed or this is not a git repository).

Using fall-back method to initialize submodule MeDiPack

Initializing MeDiPack '46a97e1d6e8fdd3cb42b06534cff6acad2a49693'
================================================== ===================
Downloading module from https://github.com/SciCompKL/MeDiPack
Extracting archive ...
Creating identifier ...

Preparing build environment
================================================== ===================
Command: ./bootstrap
Logfile written to bootstrap.log

Running configure in folder SU2_BASE
================================================== ===================
Command: ../configure --prefix=/home/darshan/Downloads/SU2_V5 --enable-mpi
Logfile written to /home/darshan/Downloads/SU2_V5/SU2-5.0.0/conf_SU2_BASE.log

Running configure in folder SU2_AD using CODI
================================================== ===================
Command: ../configure --prefix=/home/darshan/Downloads/SU2_V5 --enable-mpi --enable-codi-reverse

There was an error while running command '../configure --prefix=/home/darshan/Downloads/SU2_V5 --enable-mpi --enable-codi-reverse'.
=== Error Log ===
configure: error: AMPI library not found in externals/adjointmpi. Use 'preconfigure.py --autodiff --enable-mpi' to download it.


All times are GMT -4. The time now is 21:40.