|
[Sponsors] |
Errors running Caradonna (rotating blade) test case |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 28, 2013, 11:28 |
Errors running Caradonna (rotating blade) test case
|
#1 |
New Member
Alejandro García Soto
Join Date: May 2013
Posts: 3
Rep Power: 12 |
Hi,
I'm still learning, so probably i'm missing something obvious. When I try to run the caradonna test case, it shows a lot of points with negative pressure and then start iterations, every iteration says "nan". The original test case configuration file looked for a mesh file with a slightly different name, so I changed that. Everything else is equal. Anyone have any idea what may be wrong? Thank you!! Last edited by Gaso; May 28, 2013 at 11:38. Reason: adding information on what changed from original configuration file |
|
June 13, 2013, 18:17 |
|
#2 |
Super Moderator
Thomas D. Economon
Join Date: Jan 2013
Location: Stanford, CA
Posts: 271
Rep Power: 14 |
Hi,
Sorry that you have found some problems with the Caradonna test case. Unfortunately, this configuration file (and mesh) are a bit outdated and, because we have recently changed the periodic boundary conditions, it is unlikely that this case will work with the later versions of the code (2.0+). You might try running this case with version 1.0 of the code. Apologies and all the best, Tom |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 13:21 |
AMI speed performance | danny123 | OpenFOAM | 21 | October 24, 2020 04:13 |
Case running in serial, but Parallel run gives error | atmcfd | OpenFOAM Running, Solving & CFD | 18 | March 26, 2016 12:40 |
Errors in running a icoFsiFoam case | jin_xu | OpenFOAM Pre-Processing | 0 | June 9, 2008 06:48 |
How to save a case running in background | us | FLUENT | 0 | July 6, 2005 10:43 |