segmentation fault
 

Hello,

I have recently started using SU2 for my research work. I have the following question:

I used the pointwise software to generate a 2D mesh of SU2 format.But when I used the SU2 to compute the airfoil,it always appeared segmentation fault while it got to the solution preprocessing.How should I deal with the problem.
Thanks,

Mandar

Could you please be more specific about the problem? SU2 version, config file, etc? Have you try the tutorials?

Best,
Francisco

Hello:
I am using the SU2v2.0 and the config file is the inv_NACA0012.cfg.I used pointwise software to build a unstructed mesh for NACA6412 airfoil and changed the boundary condition definition of config file to be consistent with the definition in the pointwise.However,when I used the SU2 to compute,it always appeared segmentation fault.

Thanks.

wangjian,

I think in your post dated November 2, 2013, 07:18 you copy-pasted one of my messages along with my name!

Mandar Kulkarni