Any way to define more than one rotating frame?

JinZhiyi · April 13, 2014, 03:45

Dear developers and users:

I want to use su2 to analysis the flow around a quad-rotor uav, which have 4 rotating blades.

I am wondering if it is possible to define multi-rotating centers in config file, do i need to have multi-zones in the mesh file, or any suggestions for this kind of analysis by su2.

Thanks in advance

Jin

economon · April 13, 2014, 20:20

Hi Jin,

At the moment, it is not possible to define multiple rotating reference frames. You might want to read some more information about the current capabilities in the code related to this topic in the thread here: http://www.cfd-online.com/Forums/su2...nce-model.html.

I should also mention that we are starting to implement an actuator disk boundary condition in the code, and this would enable the type of simulations that you mention (modeling each of the 4 blades with a disk). Stay tuned for more info on that topic in future releases.

Hope this helps,
T

April 13, 2014, 03:45	Any way to define more than one rotating frame?	#1
JinZhiyi New Member JinZhiyi Join Date: Feb 2014 Posts: 14 Rep Power: 12	Dear developers and users: I want to use su2 to analysis the flow around a quad-rotor uav, which have 4 rotating blades. I am wondering if it is possible to define multi-rotating centers in config file, do i need to have multi-zones in the mesh file, or any suggestions for this kind of analysis by su2. Thanks in advance Jin

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Rotating mesh in a moving reference frame	mafz1g11	FLUENT	1	March 23, 2019 00:13
UDF carbon conversion	papteo	Fluent UDF and Scheme Programming	1	August 18, 2011 07:32
how to define ogmea in planar reference frame	goshawksky	FLUENT	0	November 5, 2007 21:42
Rotating Reference frame	Ketan	FLUENT	0	May 25, 2007 11:58
Rotating Reference Frame	Ketan	FLUENT	0	May 17, 2007 13:13

April 13, 2014, 20:20		#2
economon Super Moderator Thomas D. Economon Join Date: Jan 2013 Location: Stanford, CA Posts: 271 Rep Power: 14	Hi Jin, At the moment, it is not possible to define multiple rotating reference frames. You might want to read some more information about the current capabilities in the code related to this topic in the thread here: http://www.cfd-online.com/Forums/su2...nce-model.html. I should also mention that we are starting to implement an actuator disk boundary condition in the code, and this would enable the type of simulations that you mention (modeling each of the 4 blades with a disk). Stay tuned for more info on that topic in future releases. Hope this helps, T