[pranav]

Hi

I need to simulate oscillatory motion of 2D flap. For this purpose I need to move only a part of aerofoil section. I have referred to the pitching NACA64010 test cases where the oscillatory motion of entire aerofoil is simulated using rigid motion option. However, it does not allow for specifying only select boundary markers for movement. I would like to know if this can be achieved in SU2?
I have also been through the config_template.cfg file to find out various grid movement options. However, it is not clear from the file which keywords are applicable for a particular grid movement type.
Can anyone guide me about which document I should refer to find out the keywords applicable for each of the following grid movement types?
1. RIGID_MOTION
2. DEFORMING
3. ROTATING_FRAME
4. MOVING_WALL
5. FLUID_STRUCTURE
6. AEROELASTIC
7. ELASTICITY
8. EXTERNAL
9. AEROELASTIC_RIGID_MOTION

Thanks!