SU2 Mesh Adaptation Using Adjoint and Gradient-based Methods
 

Hello everyone. I'm trying to use SU2 on mesh adaptation for laminar flows. However I find no tutorial of it. After the flow equations and adjoint equations solved by SU2_CFD (cfg and mesh files for inv naca0012 are applied ), I run the command: SU2_MSH inv_NACA0012.cfg. After the routine ends, I open mesh_out.su2. Then i found there's no change in nelem(number of element?), so I wonder if the mesh has been adapted or not. It's very likely that I am doing it in the wrong way. Could someone tell me how to do it right? Much appreciated.