|February 15, 2017, 05:07||
Radial compressor simulation
Join Date: Feb 2017
Posts: 1Rep Power: 0
I'm an engineering student and i'm doing a final year project on SU2. The purpse of the project is to simulate both radial and axial 3D compressors on SU2.
Now, I'm working on the radial compressor, the problem is that i don't have a mass flow when I run the simulation. I tried both mass flow inlet and Total conditions. My mesh file is in CGNS and with Fluent the simulations worked quit well.
Any help ?
this is my last configuration file based on the test case 2D centrifugal blade.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Formulation of the Radial Acutation Disk Source||antar||OpenFOAM Programming & Development||1||March 4, 2017 16:27|
|[ANSYS Meshing] Mesh refinement in both axial & radial direction for 3D annular-tubular geometry||trbprnz||ANSYS Meshing & Geometry||2||November 8, 2016 08:00|
|Radial Equilibrium||MissCFD||CFX||1||March 25, 2015 18:49|
|[ICEM] Radial Turbine||spl||ANSYS Meshing & Geometry||0||February 2, 2015 05:07|
|Radial Load calculation||pump_passion||CFX||3||March 31, 2010 17:51|