 |
 |
 |
|
|
|
[Sponsors] | ||||
February 8, 2018, 06:01
|
Mesh adaptation
|
#1 |
|
New Member
Join Date: Jun 2012
Posts: 19
Rep Power: 13  |
Hi,
I found this wonderful presentation from Juan J. Alonso, Thomas D. Economon and Victorien Menier called "Mesh Adaptation for SU2 with the INRIA AMG Library" (https://su2code.github.io/documents/su2_dev_alonso.pdf), in which powerful mesh adaptation capabilities are presented. The presentation is dated September 2016. Has such useful tool been implemented yet? Has anyone tried it out? I can't find any mention of it in the SU2 release notes. Is it going to be part of SU2v6 maybe? Best regards, Alberto |
|
|
|
|
|
February 24, 2018, 12:32
|
|
#2 |
|
Super Moderator
Francisco Palacios
Join Date: Jan 2013
Location: Long Beach, CA
Posts: 404
Rep Power: 15 |
The INRIA AMG is a proprietary library, if I were you I would check with them. Maybe Adrien Loseille is the correct person to contact.
Best, Francisco |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| [snappyHexMesh] Snappyhex mesh: poor inlet mesh | Swagga5aur | OpenFOAM Meshing & Mesh Conversion | 1 | December 3, 2016 16:59 |
| Axisymmetric 2D mesh adaptation - ERROR | Pepe | CFX | 3 | May 30, 2011 08:28 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
| [snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |
Linear Mode
