plot an unsteady results

1988 · July 23, 2014, 12:21

hi
I want to plot pressure in unsteady simulation over time in an specific line,
I mean the vertical axis is P(which is changing by time )and horizontal one is time and it has been defined in an specific line in domain.
how can I make it in tecplot?
thanks

scott_rumage · July 24, 2014, 10:36

I am not sure if I understand your question, but it seems that you are asking about a basic process in Tecplot. Accordingly I would advise you to watch this older tutorial located here: http://download.tecplot.com/360/tutorials/external-flow/extflow_1_getting_started.htm In particular review the section titled “set XY line plot variables”.

Other tutorials that provide insight on the basics in Tecplot are here: http://www.tecplot.com/support/tutorials/tecplot-360-getting-started/

Scott

July 23, 2014, 12:21	plot an unsteady results	#1
1988 Senior Member Ali reza Join Date: Mar 2014 Posts: 110 Rep Power: 12	hi I want to plot pressure in unsteady simulation over time in an specific line, I mean the vertical axis is P(which is changing by time )and horizontal one is time and it has been defined in an specific line in domain. how can I make it in tecplot? thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Creating a tool to interpolate results	Luis Batista	OpenFOAM Running, Solving & CFD	2	April 11, 2013 08:15
Transient Run - Output "Time" in partial results?	evcelica	CFX	2	May 16, 2012 21:36
Different Results from Fluent 5.5 and Fluent 6.0	Rajeev Kumar Singh	FLUENT	6	December 19, 2010 11:33
conditions for unsteady problems	dvdromnu	OpenFOAM Running, Solving & CFD	5	November 9, 2009 02:15
Difference results between Steady and Unsteady?	Giang T Vu	FLUENT	6	May 22, 2004 06:37

July 24, 2014, 10:36		#2
scott_rumage Senior Member Scott Rumage Join Date: May 2009 Location: Seattle, WA Posts: 152 Rep Power: 16	I am not sure if I understand your question, but it seems that you are asking about a basic process in Tecplot. Accordingly I would advise you to watch this older tutorial located here: http://download.tecplot.com/360/tutorials/external-flow/extflow_1_getting_started.htm In particular review the section titled “set XY line plot variables”. Other tutorials that provide insight on the basics in Tecplot are here: http://www.tecplot.com/support/tutorials/tecplot-360-getting-started/ Scott