importing CFX results into the tecplot

mrkmrk · October 8, 2014, 12:48

I want to import Ansys CFX result file (. res) into the Tecplot(Tecplot 360 EX 2014 R1) but after importing my geometry is not displaying properly (as it is shown in these links) I will be thankful if anyone help me to fix this?

real geometry
http://tinypic.com/view.php?pic=2lo6wph&s=8
imported geometry
http://tinypic.com/view.php?pic=14deq78&s=8

Durrell4 · October 8, 2014, 18:18

Hi mrkmrk,

under Plot>Axis under the Range tab you can set to XYZ dependent and set the size factor to 1 for X,Y and Z and it will look the same as the CFX result.

Durrell

October 8, 2014, 12:48	importing CFX results into the tecplot	#1
mrkmrk Member David Join Date: Aug 2013 Posts: 72 Rep Power: 12	I want to import Ansys CFX result file (. res) into the Tecplot(Tecplot 360 EX 2014 R1) but after importing my geometry is not displaying properly (as it is shown in these links) I will be thankful if anyone help me to fix this? real geometry http://tinypic.com/view.php?pic=2lo6wph&s=8 imported geometry http://tinypic.com/view.php?pic=14deq78&s=8

October 8, 2014, 18:18	Axis Dependancy	#2
Durrell4 Member Durrell Rittenberg Join Date: May 2011 Location: Bellevue WA Posts: 38 Rep Power: 14	Hi mrkmrk, under Plot>Axis under the Range tab you can set to XYZ dependent and set the size factor to 1 for X,Y and Z and it will look the same as the CFX result. Durrell

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
velocity in a specific point in cfx results	ja.maldonado1187	CFX	1	February 13, 2013 19:58
Problem Importing Geometry ProE to CFX	fatb0y	CFX	3	January 14, 2012 19:42
Basic advice on Importing Solid Edge model to CFX needed.	stephen__white	CFX	1	February 9, 2011 18:40
Problem importing watertight model into CFX	djk1301	ANSYS	3	February 1, 2011 22:04
Importing solutions in CFX.	Alphonso	CFX	1	August 1, 2008 14:01