Forces and Moments over a 2D slice
Hi,
I made a slice of a wing section along the span (becomes 2D airfoil). Now I would like to integrate/wish to calculate forces and moments on that sliced @D section. How can I do that? |
This calculation is performed via the "Analyze" section of Tecplot 360 (found on the top menu bar). I would recommend a thorough reading of the Tecplot 360 manual's chapter 21 titled "CFD Data Analysis" (page 303) to learn how to do this work. Here is a link to the manual: http://download.tecplot.com/360/curr...ers_manual.pdf .
Ali, I do recall that you have had an issue with downloading from Tecplot's web-site in the past, but that web-site is active and so the issue is probably on your end. I note that you are located in Pakistan. If your Tecplot license is under maintenance support, you can also contact Tecplot's distributor Genias Graphics www.genias-graphics.de for assistance in answering this question. Good luck, Scott |
All times are GMT -4. The time now is 08:12. |