TECPLOT not showing anything!!!
I exported some variables from ANSYS Fluent while solving a transient case. The export format was Tecplot (.plt) format. But now, when I load those results, I cannot see any contours of pressure, velocity or vorticity. When viewed is spreadsheet (inside Tecplot) there are values for all variables, but no contours. WHY?:confused:
|
did u find it. i need th same help
did u find it. i need th same help
|
i have same problem, need help pls:(
i have same problem, need help pls:(
|
All times are GMT -4. The time now is 06:56. |