 |
 |
 |
|
|
|
[Sponsors] | ||||
How to change the position of probe with time in tecplot to perform FFT for the case |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 6, 2019, 02:10
|
How to change the position of probe with time in tecplot to perform FFT for the case
|
#1 |
|
New Member
Aamir Sultan
Join Date: May 2018
Posts: 12
Rep Power: 7  |
Hello Everyone !
I want to perform FFT for the case when a rectangular wings is oscillating in direction of roll . The vertices, being generated at the tips are also changing their locations as the wings moves. In Tecplot 360 we can only specify the coordinates of the spatial position through probe or by entering the coordinates values . So lets say if I put a point on the vortex at certain times step , in the next step the point will remain on its position but the vortex will be shifted to another position . Is there any way to move the position of probe point along with vortex at the time passes by . |
|
|
|
|
|
| Tags |
| cfd - post, cfd acoustics, fft, tecplot 360, tecplot360 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [General] Extracting ParaView Data into Python Arrays | Jeffzda | ParaView | 30 | November 6, 2023 21:00 |
| Floating point exception error | lpz_michele | OpenFOAM Running, Solving & CFD | 53 | October 19, 2015 02:50 |
| Micro Scale Pore, icoFoam | gooya_kabir | OpenFOAM Running, Solving & CFD | 2 | November 2, 2013 13:58 |
| calculation diverge after continue to run | zhajingjing | OpenFOAM | 0 | April 28, 2010 04:35 |
| DPM UDF particle position using the macro P_POS(p)[i] | dm2747 | FLUENT | 0 | April 17, 2009 01:29 |
Linear Mode
