 |
 |
 |
|
|
|
[Sponsors] | ||||
January 3, 2022, 12:38
|
Error saving layout
|
#1 |
|
Member
Adithya
Join Date: May 2021
Posts: 73
Rep Power: 4  |
Hello
I am using Tecplot to process my Fluent simulations. They have constant density and constant viscosity. In Tecplot, the fluid is set as incompressible, with only Pressure being used in my Field variables definition. After I save a layout, I cannot open the layout. I keep getting the error message that density cannot be chosen for an incompressible fluid. Anybody (Scott Fowler?) have an idea on how to fix this? |
|
|
|
|
|
January 11, 2022, 12:38
|
|
#2 |
|
Senior Member
Scott Fowler
Join Date: May 2009
Posts: 112
Rep Power: 16 |
Interesting - I've not seen this situation before. I think it might be best to have a chat with our support staff. You can reach them at support@tecplot.com and we can go through your workflow to try to figure it out.
Scott |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Error, while reopening my techplot layout file | farhan4596 | Tecplot | 3 | May 23, 2023 05:46 |
| Guideline for grid density of imported layout file in Icepak | ivanchi | ANSYS | 1 | October 13, 2015 08:24 |
| Wiki Layout | Jonas Larsson | CFD-Wiki | 3 | November 4, 2005 08:54 |
| Info About New Forum Layout | Jonas Larsson | Main CFD Forum | 19 | August 28, 2005 20:49 |
| Preview of New CFD Online Layout | Jonas Larsson | Main CFD Forum | 30 | May 26, 2005 12:52 |
Linear Mode
