|
[Sponsors] |
September 30, 2017, 06:34 |
surface roughness
|
#1 |
New Member
AbderrahmenBouchhima
Join Date: Aug 2017
Posts: 2
Rep Power: 0 |
Hi to all
I am modelling a turbulent flow in a pipe. I used the standard K-Epsilon model.In the inlet I used groovy Bc(for the velocity) for turbulent flow. My aim is to see the effect of surface roughness on the velocity profile. So I used nutRoughWallFunction (0/nut) with different values of Ks and Cs but the velocity profile remain the same. I tried nutWallfunction and the result is the same. coud any one help me with this issue ? thanks in advanced |
|
April 18, 2018, 11:25 |
|
#2 | |
New Member
Jesse Cheung
Join Date: Apr 2018
Posts: 18
Rep Power: 8 |
Quote:
|
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
[ANSYS Meshing] generation mesh for simulation surface roughness in fluent | kamyarmech | ANSYS Meshing & Geometry | 2 | February 29, 2016 13:09 |
simulation of effect surface roughness on aifoil | kamyarmech | FLUENT | 1 | February 28, 2016 09:33 |
Surface Roughness | Magnus123456 | FLUENT | 0 | January 22, 2014 10:32 |
Surface Roughness Laminar Flow | cmh | OpenFOAM Pre-Processing | 0 | July 10, 2013 07:19 |