|
Exact dimension of elbow geometry in tut
4 Attachment(s)
Hi every one
I am following tutorial on DM and trying to use a different method to do the same geometry. but i am not able to get the dimension of small inlet: 1. Where to put it 2. I am not getting length as 3 inch of small pipe length at one end and 4 inch on the other end (on two end of diameter) Here is the link of my geometry https://dl.dropboxusercontent.com/u/...eep_elbow.wbpz Here is the link of tutorial http://www.rose-hulman.edu/~luic/ME4...ng%20Elbow.pdf http://www.cfd-online.com/Forums/att...1&d=1405267037 http://www.cfd-online.com/Forums/att...1&d=1405266871 http://www.cfd-online.com/Forums/att...1&d=1405266871 http://www.cfd-online.com/Forums/att...1&d=1405266871 |
In the newer versions of this tutorial, the position of the small inlet is well-defined.
I guess you are not the first engineer who had trouble getting the "correct" position from this drawing ;) |
version 15 tut ?
Just uploaded videos on YouTube.com 1. Elbow in DM http://www.youtube.com/watch?v=TPrn58TQnl4 2. Elbow meshing in ICEM CFD http://www.youtube.com/watch?v=aSCA-3ezvxA ---------------------------------------- Edit: Yes I got them. The older tutorial was well defined for gambit, but not the DM |
| All times are GMT -4. The time now is 06:14. |