[Far]

Hi every one

I am following tutorial on DM and trying to use a different method to do the same geometry. but i am not able to get the dimension of small inlet:

1. Where to put it

2. I am not getting length as 3 inch of small pipe length at one end and 4 inch on the other end (on two end of diameter)

Here is the link of my geometry
https://dl.dropboxusercontent.com/u/...eep_elbow.wbpz

Here is the link of tutorial
http://www.rose-hulman.edu/~luic/ME4...ng%20Elbow.pdf