CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ICEM] Error: no existing mesh part specified (

DoubleG December 11, 2012 11:11

Error: no existing mesh part specified
1 Attachment(s)
When I make a geometry with closed surfaces and a material point within the domain, I get the following error:

"No existing mesh part specified. Please run "Tetra from Geometry" if you don't have any existing mesh"

Does anybody know what's wrong?

I usually don't have this error. When I do this geometry just after a reboot it works fine, but it seems to happen just after running one specific mesh.

Thanks in advance,

Rikki-Tikki-Tavi August 7, 2017 07:32

I have this Problem as well. Does anyone know the answer to this?

All times are GMT -4. The time now is 20:55.