How to mesh my 3D geometries correctly
Hello
Regarding to my concentric and eccentric . I have read and downloaded many papers and tutorials about and my knowledge now is better. but have some specific quires: 1- What is the advantage from drawing sub volumes and 4-planes . 2- Periodic and wall ( Outer Wall ) what r the differences. The main point is how to mesh my 3D geometries as in my drawing I have followed the next: 1- Volume>cylinder> draw two cylinders then subtract them. now how to set my mesh (64X16X48) to get 49152 cells only , As firstly when I was drawing by sweep faces the no. of cells was 98400 by using same point above , http://s1280.photobucket.com/user/om...f717e.jpg.html |
|
All times are GMT -4. The time now is 09:41. |