Exporting to TurboGrid
 

Hello :)

I have created in Blademodeler Rotor and Stator of the fan with ExportPoints. Since it is in one Geometry block I have problems to export the rotor and stator to different Turbogrind - it only exports the ExportPoints which was created earlier (rotor).
Is it possible to export from one Geometry to two TruboGrids?
Anticipating the answer that I shoudl duplicate the Geometry and Suppress- I had made some dependencies between Rotor and Stator which are defined as parameters.
Thanks for any help.

Best regards

Hi adinacatslowo.

Yes, you can export from one geometry to two turbogrids. In workbench, open the "properties of Schematic: Turbo Mesh". There you have an option for geometry selection, and you can choose the appropriate FlowPath and Bladerow Number.

Best regards,
SG

Thanks alot :)