Need Help in Meshing Control
 

Hi guys. I'm doint a 2D problem where two surface bodies are bonded on a shared edge. After I did the mesh I found that it doesn't have continuity on the edge. I want the mesh in which two bodies have the same nodes on the edge, is there any way to do this?

I tried with mesh connection, it looks perfect like the one I want, buy after I clicked SOLVE, it can't work.

Here is my mesh now, hope some of you may help me. Thanks in advance.
http://www.cfd-online.com/Forums/mem...ure825-111.png

Put the two parts into a Multi Body Part in DesignModeler, this will share the edge and make a node conformal mesh.

You can introduce Match Control. See this and this.

Thanks so much. I did it following your suggestion.