ICEM CFD meshing lock edge mesh size
 

i am having trouble that if i change mesh size near inlet (even without switching on copy parameters), the mesh size near output edge changes and viceversa.. occurs in outlet side meshing...

so i was able to get good mesh near inlet or outlet....


i like to mention also that there are some other blocks of different structures inbetween. then how the inlet and outlet edge interlinked.....

is there a way to lock one end edge mesh size and do the other......:(:(

please give certain idea thank u for any reply....

correction for better understanding
 

i am having trouble that if i change mesh size near inlet (even without switching on copy parameters), the mesh size near output edge changes and viceversa.. occurs in outlet side meshing...

so i was able to get good mesh near inlet or outlet.... but not on both side of 3d meshing


i like to mention also that there are some other blocks of different structures inbetween. then how the inlet and outlet edge interlinked.....

is there a way to lock one end edge mesh size and do the other......:(:(

please give certain idea thank u for any reply....