CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (https://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] bed elements on a curve (https://www.cfd-online.com/Forums/ansys-meshing/190096-bed-elements-curve.html)

gaza July 5, 2017 04:39
bed elements on a curve
 
1 Attachment(s)
Hi All,
Can anybody help me how to avoid such bad elements in the circular curves
shown in the attached figure?

There is a curve for sure because I created it manually.
https://www.cfd-online.com/Forums/da...BJRU5ErkJgggA=

alur July 5, 2017 10:40
Quote:
Originally Posted by gaza (Post 655885)
Hi All,
Can anybody help me how to avoid such bad elements in the circular curves
shown in the attached figure?

Give mesh, try to help you. metalist93@gmai.com

gaza July 8, 2017 03:17
Quote:
Originally Posted by gaza (Post 655885)
Hi All,
Can anybody help me how to avoid such bad elements in the circular curves
shown in the attached figure?

There is a curve for sure because I created it manually.
https://www.cfd-online.com/Forums/da...BJRU5ErkJgggA=
Ok I found that there was two curves (at the surface intersection) and each of them belonged to the other surface (they appeared after extract curves from surface command). I had to delete one of them and now it is OK.


All times are GMT -4. The time now is 23:50.