ICEM does not show the Premesh
Hello Experts and happy new year :)
I am meshing a series of airfoils with some small differences. I have imported a new geometry (parasolid: *.xt) into an existing ICEM file ( and replaced the geometry with the existing one). Then I did all the associations again. The edges are fine and associations are correct and there is no error. However, I cannot see PREMESH. (NOTE THAT THE PREMESH EXISTS, SINCE I CAN CONVERT IT TO AN UNSTRUCTURED MESH, BUT THE SOFTWARE DOES NOT SHOW IT). Does anyone know how to display the PREMESH (in 2019-R3)? Best regards, |
Hello,
Is the box beside the Pre-Mesh in the Blocking tree checked off? |
I have checked it..it was already ticked...
The solution was to associate faces as well. Thanks for your help in responding. |
Hello Mohammad,
Good show, that was to be my next suggestion. All the best. |
All times are GMT -4. The time now is 20:01. |