Cfx solver manager: How to set correct y-axis value of pressure in monitor graph.
Hi all,
I set the total pressure monitor at inlet to monitor my solution during run in cfx solver manager. I set 1.4MPa total pressure at inlet but the graph is showing 0MPa. I don't know how to fix y-axis of graph? Picture is attached. I know its basic question but I am a beginner. It is very important for me. Please help if anyone know.... thanks |
Quote:
|
Hi antanas,
- My initial condition at inlet set to total pressure 1.4MPa with total temp 550 deg Centigrade. - Fluid model set to Total energy.(supersonic flow) - Expression for pressure monitor at inlet = areaAve(Total Pressure)@inlet Please suggest. Thanks |
Quote:
|
Hi Mfaizan
In your screen shot it is not 0 MPa.Please click your cursor on the Monitor line to get the actual value. You can adjust your monitor point range by right click on the solver window -> Monitor properties ->Range settings ->adjust Lower bound & Upper bound Value. |
Quote:
|
dear bharat,
thanks a lot for your assistance. Yes after changing range I saw the 1.4MPa value but it I am still confused that with constant 1.4MPa total pressure boundary condition at inlet why this large negative value of pressure is appearing in the model. I checked the lowest value by putting my cursor on the monitor and it is showing -1.7e7. This is crazy. If you can assist then please explain this. One more question that how can I change the X-axis settings of the pressure monitor tab. Please reply. |
When the simulation is partially converged the results can show anything. Don't worry about crazy intermediate results - the final converged solution is all that matters.
|
Thanks ghorrocks!
|
All times are GMT -4. The time now is 21:34. |