cfx profile data
 

Hi every body
I am simulating solar chimney , firstly i set 22c for uniform inlet temperature
but when i saw the result in cfd post, temperature was not uniform.
because of this i have to use profile data.
i have question about making profile data in 3d when your surface is periodic
and if i set temperature just in one line( my line in picture), is this correct or not???
my profile data and picture of solar chimney are attached.
thanks so much.

Before embarking into something else, have you looked into the Conservative and Hybrid differences at the inlet ?

Conservative values will be different than the user specified values, say 22 [C] and they do not have to be uniform.