cfx profile data

svaezi · September 18, 2016, 03:57

Hi every body
I am simulating solar chimney , firstly i set 22c for uniform inlet temperature
but when i saw the result in cfd post, temperature was not uniform.
because of this i have to use profile data.
i have question about making profile data in 3d when your surface is periodic
and if i set temperature just in one line( my line in picture), is this correct or not???
my profile data and picture of solar chimney are attached.
thanks so much.

Opaque · September 19, 2016, 08:51

Before embarking into something else, have you looked into the Conservative and Hybrid differences at the inlet ?

Conservative values will be different than the user specified values, say 22 [C] and they do not have to be uniform.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ansys CFX 14.5 + trasnient "initialize profile data"	lentschi	CFX	4	June 28, 2013 07:15
Inlet boundary conditions from profile data	M_Tidswell	CFX	2	April 29, 2013 09:17
Initialise Profile Data	Aloise	CFX	3	December 9, 2006 10:39
Profile Data Velocity Boundary Condition Changes??	Maria Angelica	CFX	9	June 14, 2006 02:44
CFXSolver Error Message using Profile Data on B	Tobias	CFX	0	August 26, 2005 07:27

September 19, 2016, 08:51		#2
Opaque Senior Member Join Date: Jun 2009 Posts: 1,812 Rep Power: 32	Before embarking into something else, have you looked into the Conservative and Hybrid differences at the inlet ? Conservative values will be different than the user specified values, say 22 [C] and they do not have to be uniform.