ICEM CFD 5.0 - CFX mesh problem
 

I tried to model by using Tet mesh, after mesh, there always an error saying "there is a hole in the geometry", how could I fix this? Actually there is no hole in my model.

Re: ICEM CFD 5.0 - CFX mesh problem
 

Try to decrease the triangulation tolerance under the global mesh tab.

Create an external mesh
 

Hi,

i don't know if it is possible to create an external mesh. I need to pass water in a catamaran hull, and i would like to do it like in FloWorks (the assembly in a BOX (boundary condition)). Is it possible?

Hugo Ferreira www.dee.isep.ipp.pt/~e980933