FSI - wind-induced vibration of plate
 

Hi All,

I simulate wind-induced vibration of plate using FSI (transient structura - CFX)

In Structural, I defined remote displacement of side of plate. (see Fig2).
the condition of remote displacement is x: 0, Y: free, z: 0, rot-x: 0, rot-y: 0, and rot-z:Free. Because I would like to see vibrate at Y-dir and rotate z-dir. (it is same condition of wind tunnel test).

but, I have an error of CFX via FSI.
1. Mesh folded error. I alread poted thread about this error but still problem.

ANY IDEAS are welcome