warning while defining wall motion
 

Valve boundaries (1) min lift (0.000000) specified in motion file (pistondef1305.in) is inconsistent with expected geometry setup min lift (-1.000000). Please double-check.
am getting this error when I am defining user-defined BC of the piston motion
I have no valves in my geometry...am simply defining a user-defined piston BC motion instead of converge to use it wrt piston motion...the file am using is attached below.
Any suggestion apprecaited.

Hi Usama,

The text file looks fine to me. Could you try importing the profile again to see if that works. It could be possible that it is reading in an old file which hasn't been overwritten.

Praveen