warning while defining wall motion

usamaubk · May 14, 2021, 06:59

Valve boundaries (1) min lift (0.000000) specified in motion file (pistondef1305.in) is inconsistent with expected geometry setup min lift (-1.000000). Please double-check.
am getting this error when I am defining user-defined BC of the piston motion
I have no valves in my geometry...am simply defining a user-defined piston BC motion instead of converge to use it wrt piston motion...the file am using is attached below.
Any suggestion apprecaited.

psrikanth · May 14, 2021, 18:42

Hi Usama,

The text file looks fine to me. Could you try importing the profile again to see if that works. It could be possible that it is reading in an old file which hasn't been overwritten.

Praveen

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CFD by anderson, chp 10.... supersonic flow over flat plate	varunjain89	Main CFD Forum	18	May 11, 2018 07:31
[swak4Foam] installation problem with version 0.2.3	Claudio87	OpenFOAM Community Contributions	9	May 8, 2013 10:20
[blockMesh] error message with modeling a cube with a hold at the center	hsingtzu	OpenFOAM Meshing & Mesh Conversion	2	March 14, 2012 09:56
[Gmsh] discretizer - gmshToFoam	Andyjoe	OpenFOAM Meshing & Mesh Conversion	13	March 14, 2012 04:35
Cells with t below lower limit	Purushothama	Siemens	2	May 31, 2010 21:58

May 14, 2021, 18:42		#2
psrikanth New Member Praveen Srikanth Join Date: May 2021 Location: Convergent Science, Madison, WI Posts: 19 Rep Power: 5	Hi Usama, The text file looks fine to me. Could you try importing the profile again to see if that works. It could be possible that it is reading in an old file which hasn't been overwritten. Praveen