DPM BC "Reflect" for Pressure Outlet
Hi I am simulating a wave tank where one side is a velocity inlet and other side is a pressure outlet. But after the DPM injection I set both the BC for the inlet and outlet as "Reflect" in the DPM tab in the BC conditions of each. I wanted to keep the limited particles inside the system though the water flow is like a channel. I'm not sure if it's working.
Does DPM particles leave the system through outlets even though the BC of the outlets are set as "Reflect/Trap"? Thanks a lot in advance |
All times are GMT -4. The time now is 18:19. |