buckngnr11 |
May 23, 2020 18:27 |
Conjugate Parallel Issue!
Hello. I'm not too familiar with conjugate simulations in Fluent, but I created my mesh and set up my contact interfaces and boundary conditions in serial mode. Was able to run without issue but need to be able to open in parallel. I saved the .cas and .dat files, and when I try to reopen with more than 1 processor, I get a cortex exception. It appears to be an issue with the interfaces and maybe partitioning them, but Fluent recognizes these contact interfaces automatically when the mesh is loaded so I don't know how to get around this problem? If I try to start from scratch and load in the .msh file in parallel mode, it fails when the adjacent interfaces are being read.
|