Open Channel Flow
Hi,
I have gone through the forum archive but haven't found the answers for successful simulation of open channel flow. I hope some one has answers to my set of questions. a) In Open Channel Flow, if I use pressure inlet, do I have to make two different inlets if the case being simulated is layer of air on top of water? b) When I try to patch the VOF value of secondary phase as 1 using registers for the area occupied by the water and then export the volume-fraction of secondary phase, I only see the value 1 on the inlet side and not in the whole domain?? c) For the Open Channel Flow simulation, the density in the whole domain should vary between 1.225 kg/m3(air) to 998.2(kg/m3) right? Any help will be greatly appreciated. Thanks, Sumit |
All times are GMT -4. The time now is 08:20. |