|
[Sponsors] |
October 1, 2009, 03:01 |
Open Channel Flow
|
#1 |
New Member
Sumit Sinha
Join Date: Mar 2009
Location: Champaign, ILLINOIS, U.S.A
Posts: 25
Rep Power: 16 |
Hi,
I have gone through the forum archive but haven't found the answers for successful simulation of open channel flow. I hope some one has answers to my set of questions. a) In Open Channel Flow, if I use pressure inlet, do I have to make two different inlets if the case being simulated is layer of air on top of water? b) When I try to patch the VOF value of secondary phase as 1 using registers for the area occupied by the water and then export the volume-fraction of secondary phase, I only see the value 1 on the inlet side and not in the whole domain?? c) For the Open Channel Flow simulation, the density in the whole domain should vary between 1.225 kg/m3(air) to 998.2(kg/m3) right? Any help will be greatly appreciated. Thanks, Sumit |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Version 15 on Mac OS X | gschaider | OpenFOAM Installation | 113 | December 2, 2009 11:23 |
open channel problem (free surface) | Andy Chen | FLUENT | 4 | July 10, 2009 02:20 |
pressure outlet (open channel flow) | Willem Brantegem | Main CFD Forum | 0 | April 3, 2007 10:39 |
Open Channel flow Boundary | khalid | FLUENT | 1 | November 4, 2006 12:53 |
SIMPLE Scheme for open channel flow | ao | Main CFD Forum | 0 | April 6, 2004 17:21 |