CFD Online Discussion Forums

CFD Online Discussion Forums (
-   Main CFD Forum (
-   -   Simple Meshed Edges Problem (

Rich February 8, 2005 14:29

Simple Meshed Edges Problem
Hi There,

I have a problem with meshing connected, aligned edges: I have four edges in line with each other. I want Gambit to treat the four edges as one edge when it goes to mesh them.

This needs to be done so that the nodes are distributed appropriately along the entire length of the four edges when a ratio is applied.

Any advice would be great

Thanks Rich

David February 9, 2005 02:38

Re: Simple Meshed Edges Problem
Try to merge the four edges. It may create virtual line which can be meshed and does not break previous faces. Or when you first delete the face it creates you can make the merged line real. Could be...

All times are GMT -4. The time now is 08:57.