no 3D mesh for 2D geometry in Salome
1 Attachment(s)
Dear,
I am trying to mesh a 2D geometry in salome. The geometry was created via the extrusion of a face. I have defined the algorithms and hypotheses as shown in the picture. But the mesh generation is always failed. I am really appreciated for any kind help. Since the salome file is very large, I could send you via email, if possible. Thank you in advance. Best Regards, Bill |
mesh computation failed
1 Attachment(s)
Dear,
I wonder why this problem occur? I have tried other geometries and there is no error? Could any one give some suggestions? Thank you in advance. Best Regards, Bill |
Solved
I found a link here
http://www.salome-platform.org/forum/forum_10/138954355 Hope this will help the new learners of Salome. |
All times are GMT -4. The time now is 15:38. |