Periodic GGI, How to
1 Attachment(s)
Hello to FOAMing users,
may I ask you to show me how to set up case with periodic boundary condition (periodic GGI), which are implemented in OF1.5-dev. Here is typical picture (see below) with testing case. Boundary conditions are set up like this: - inlet: total pressure - outlet: static pressure - stator: wallFunctions - periodic boundary condition: something like cyclic patch, which make possible to use non-conformal. In the later, I can post some mesh on the forum, which is prepare for using periodic ggi. Many thanks in advance, David |
All times are GMT -4. The time now is 04:37. |