two-phase flow simulation through a porous media
 

Hi everyone, I am relatively new to OpenFOAM and I have tried with no success to pass a flow through a fibrous material I generated. I looked up this forum and other sources to get to where I am now using OpenFOAM. I meshed the pore space of the fibrous structure to Simulate flow and the flow seems to stop at the inlet. Someone checked it out on paraview and adjusted my velocity scale and it looked like there was flow.


However, I did surfaceCheck and can see that for the fibre, the surface is not closed. Could this affect it?

https://files.slack.com/files-pri/TJ...A56Y/image.png